环境监测在生态环境保护中的效用及发展措施研究

环境监测在环境保护中起着重要的作用,伴随着环境保护法的进一步落实,使我国的环保措施及标准有了越来越规范的准则。可从实际工作情况看,监测机构监测水平较低、设备滞后、监督不严格等问题依然存在因此,要全面提高环境监测水平,加大对环境监测工作的重视程度。本文主要以环境监测在生态环境保护中产生的作用入手,提出了一些完善措施。     

环境检测的作用及环保措施分析

本文对环境检测的作用进行了总结,包括环境检测是环境影响评价的基础、环境检测是环境保护的依据、环境检测促进环境管理工作等,提出了环境保护措施,需要增加资金投入力度、完善环境检测法律保障体系、合理使用环境检测新技术、构建环境检测质量控制体系、完善环境监管保护方法来有效地保护环境,提升人们的生活质量。     

Study of the influence of melamine polyphosphate and aluminum hydroxide on the flame propagation and explosion overpressure of aluminum magnesium alloy dust

When aluminum magnesium alloy dust floats in the air, a certain ignition energy can easily cause an accidental explosion. To prevent and control the occurrence of accidental explosions and reduce the severity of accidents, it is necessary to carry out research on the explosion suppression of aluminum magnesium alloy dust. This paper uses a vertical glass tube experimental device and a 20 L spherical explosive experimental device to carry out experimental studies on the suppression of the flame propagation and explosion overpressure of aluminum magnesium alloy dust with melamine polyphosphate (MPP) and Al(OH)₃. With increasing MPP and Al(OH)₃ concentrations, the flame brightness darkened, the flame velocity and propagation distance gradually decreased, and P_max and (dp/dt)_max decreased significantly. When the amount of MPP added reached 60%, the flame propagation distance decreased to 188 mm, which is a decrease of 68%, and the explosion overpressure decreased to 0.014 MPa, effectively suppressing the explosion of aluminum magnesium alloy dust. The experimental results showed that MPP was more effective than Al(OH)₃ in inhibiting the flame propagation and explosion overpressure of the aluminum magnesium alloy dust. Finally, the inhibitory mechanisms of the MPP and Al(OH)₃ were further investigated. The MPP and Al(OH)₃ endothermic decomposition produced an inert gas, diluted the oxygen concentration and trapped active radicals to terminate the combustion chain reaction.     

肥煤自燃全过程热动力学特征参数研究

实验测定了林西矿肥煤样品30~900℃煤自燃全过程热动力学特征参数,得出:TG/DTG曲线显示煤样DTG初始临界温度45℃,干裂温度122℃,活性温度195℃,增速温度265℃,质量极大值温度342℃,着火温度465℃,最大热失重速率温度515℃和燃尽温度690℃;DSC曲线显示,煤样初始放热温度60℃、最大热释放速率温度511℃。结合TG-DTG-DSC曲线综合分析可知,煤温达到510℃左右时煤样反应最剧烈。由煤自燃标志气体测定实验系统得出:煤温130℃后CO,CO 2释放量迅速增加,210℃增加速度下降;CH 4,C 2 H 6含量变化具有规律性且两者变化相近;C 2 H 4出现温度为130℃;C 2 H 4/C 2 H 6比值在190~350℃有较强的规律性,呈上升趋势且上升速度较快;350℃之后,CH 4,C 2 H 6,C 2 H 4体积分数均开始急剧增大;C 2 H 4/CO与C 2 H 4/CO 2变化趋势大致相同,在130~350℃时缓慢增长,达到350℃后比值呈指数形式上升。经拟合曲线,得到活化能的3个突变点温度:70,180,220℃,其中180℃与交叉点温度相吻合。通过以上研究,得到了肥煤自燃全过程的热力学特征参数,为实际生产中防治煤自燃提供了理论依据。     

The passion bug: How and when do leaders inspire work passion?

Drawing from signaling theory, we propose a work passion transfer model where leaders' passion is transmitted to employees through the former's leadership style and is contingent on employees' perceived importance of performance to self-esteem (IPSE). Data from 201 supervisor–employee dyads from the health-care industry show that leaders' harmonious passion led to employees' harmonious passion through charismatic leadership, whereas contingent reward leadership accounted for the transfer of obsessive passion; IPSE did not play a moderating role for either form of passion. Results from a supplementary study further reveal that the link between leadership and employee passion operated through employees' perception of leader passion and that employees' IPSE accentuated for the relationship between perceived leader obsessive passion and employees' obsessive passion. This study advances research in work passion, leadership, and signaling theory and provides important implications for managerial practice.     

“Science is Everywhere,but No One Knows It”: Assessing the Cultural Distance to Science of Rural South African Publics

ABSTRACT

In science communication, a prerequisite for reaching different parts of a society is to find out how these publics experience and interpret science. Since rural South African publics are perceived to exhibit a large cultural distance to science, the present exploratory study aimed to know in more detail how rural South Africans perceive and understand science in their local and social contexts. Theoretical notions on cultural distance and the methodological approach of segmentation studies were considered. Semi-structured interviews with rural South Africans were carried out in four towns (n?=?52) that differ with respect to having a large scientific installation in their vicinity, or not. Sensitively comparing local and social contexts helped identifying three different publics who differed regarding their perceptions of science; however, the large scientific installations only made a difference in perceptions for those publics who were generally less exposed to and less knowledgeable about science.     

植物内重金属的赋存形态及分布特征分析方法研究进展

植物内重金属分析不仅有助于阐述重金属迁移转化规律,揭示植物修复机理,也是监测评价大气、水及土壤环境重金属污染状况的重要依据。研究针对植物样品中重金属赋存形态及分布特征的分析方法进行综述,分别介绍了其原理、优缺点及应用。提出制定统一高效的分析检测方法,深化植物内重金属的赋存形态及分布特征与环境相关性的研究以及建立数据共享平台是植物样品重金属信息分析方法的未来发展方向。     

瑞典的水环境保护经验及对我国的启示

介绍了瑞典的水环境保护法规政策、水环境保护机构、污水处理体系及其在水环境保护方面的特色做法。结合目前我国水环境管理所处的阶段,从顶层设计、宣传教育、项目管理、污染防治等方面,总结了瑞典经验对我国水环境保护工作的启示。     

Improving pedestrian safety using combined HOG and Haar partial detection in mobile systems

Objective: The objective of this study is to develop a novel algorithm on a mobile system that can warn drivers about the possibility of a collision with a pedestrian. The constraints of the algorithm are near-real-time detection speed and a good detection rate.

Method: Histogram of gradients (HOG)-based detection is widely used in pedestrian safety applications; however, it has low detection speed for real-time systems. Hence, it has no direct usage for mobile systems. In order to achieve near-real-time detection speed, partial Haar transform predetections are applied to an image before HOG detection. The partial and HOG detections are merged and a score-based confidence level is defined for the final detection phase. In this way, the outcome is prioritized and different warning levels can be issued to warn the driver before a possible pedestrian collision.

Results: The proposed algorithm provides an increase in detection speed (from 46 to 76 fps) and detection rate (from 80 to 91%) with respect to HOG-based pedestrian detection. It also improves confidence of the results by multidetection merging and score assignment to detections.

Conclusions: Performance improvement of the algorithm is compared with respect to state-of-the-art detectors/algorithms. Based on the detection rate and detection speed performance, it can be concluded that the proposed algorithm is suitable to be used for mobile systems to warn drivers about the possibility of collision with a pedestrian.     

Usage of polystyrene disposable food dishes in the lightweight concrete making

The increasing use and subsequent accumulation of polystyrene containers has triggered a substantial environmental problem. This study investigated using varied percentages of solid waste polystyrene disposable food dishes in the production of lightweight concrete samples with 350 kilograms per cubic meter (kg/m³) of cement and a density of 1,300 kg/m³. The polystyrene disposable dishes were ground into beads of 0–3 millimeters (mm) and 3–6 mm in size. First, the characteristics of Type II Portland cement, polystyrene, and aggregates were examined. The following characteristics of concrete using ASTM International and British Standards Institution standards were tested: slump, compressive strength, ability to resist chloride ion penetration, and resistance of concrete to rapid freezing and thawing cycles. Scanning electron microscopy (SEM) and energy dispersive X‐ray spectroscopy analytical techniques were also used. The slump of samples varied between 40 and 70 mm and was not dependent on either the polystyrene percentage or the size of the polystyrene beads in the concrete samples (p‐value > .05). The compressive strength of the concrete samples after 90 days of curing, and using different percentages of polystyrene, varied between 96 and 113 kilograms per square centimeter (kg/cm²). The resistance of the samples to the freezing and thawing cycle and chloride ion penetration were affected unfavorably by the presence of the polystyrene. The SEM technique indicated that concrete samples containing 15% and 25% polystyrene had denser crystals and less void than concrete samples with 40% and 55% polystyrene.